Draw Bolt
Command - PrB_ArxBolt
This command draws a single bolt through a plate or profile.
At the command line prompt, select a part, then the following dialog will appear:
Here you are able to select:
- The Bolt-assembly
- Bolt diameter
- Penetration length (Grip) = the plate thickness
- Hole tolerance (Bolt hole clearance)
- Added length - The bolt length is calculated as: (Length = Penetration length (Grip) + Washers + Nuts + Added length)
If the 'Bolted in workshop' checkbox is checked, then it is assumed that the assembly is at least partly bolted in the shop.