Command - PrB_ApplyMacroManually

At the time of writing, this command was not yet supported in BricsCAD.


This command does approximately the same as Copy a macro automatically, but it serves as a backup in case the latter fails.

The latter may abort the macro copy when the sub-geometries that you selected differs too much.

In that case you can use this command to redo the manual copy operation.

This command differs from the other macro copy command in the following ways :

  • It will prompt for you to select more sub-geometries because it does no assumptions
  • It has no geometric rules checking mechanism that aborts on rule combinations that are impossible to calculate.
    This is not a problem as long as you test your macros thoroughly and make sure there are no degrees of freedom!