Verifying new holes

Command : S3d_HoleCheck

The command Verifying new holes allows Parabuild to check if there is a plate or beam with a bolt inserted but without a hole.  In this case Parabuild will draw the hole.

You activate the command and select by crossing the beams, plates and bolts:

The result:

Warning: If the bolt is too close to the edge of a beam or plate or if it is too close to another bolt, it will be coloured red and no hole will be drawn.  If this is the case, you need to move the bolt or change the settings: reduce the bolt to edge or bolt to bolt distance in the Global settings) dialog box.