Clash control

Preparing the 3D-drawing ››
Parent Previous Next

Commando : S3d_FullClash

       

You can use this command to check for clashes between elements.

If a plate clashes with a beam, both will be coloured yellow. This will immediately show errors in the design or drawing.

 

Bolts are coloured yellow when they are too close to a plate or beam. Bolts will be coloured red if they are drawn in the air or if they are too close to the edge of a beam or plate that they are piercing. The maximum distance between a bolt and the edge of a beam or plate can be set in the Global settings dialog box.